Dascom T2150 Quick Reference Guide Bedienungsanleitung PDF herunterladen

Quick Reference Guide

Load Paper

Step 1

Raise front cover, then open tractor flaps.

Step 2

Adjust tractors for paper width. Green lever unlocks/

locks (up is locked).

Step 3

Stack paper directly below tractor path.

Step 4

Press Load Key.

Step 5

Press Online Key.

Install Ribbon

Step 1

Press Online Key (places printer offline) then remove

top cover by depressing spring loaded levers and

lifting up.

Step 2

Move print head to left side. Raise upper friction guide

and remove used cassette.

Step 3

Turn colored ribbon feed knob in order to take up

slack of the ribbon.

Step 4

Tilt ribbon cassette forward parallel to the housing top

and thread in ribbon in front of print head.

Step 5

Locate the two notches in the left and right guide rails

of the printer and press down on both sides until it

clicks into place.

Step 6

Turn colored ribbon feed knob again. The ribbon will

slide over the plastic guides on the left and right of the

print head into the correct position.

Step 7

Press the upper friction guide down until it clicks into

place.

Step 8

Remount and close top cover. Press Online Key

(places printer online)

90˚

1 2

Inhaltsverzeichnis

Seite 1 - Install Ribbon

Quick Reference GuideLoad PaperStep 1Raise front cover, then open tractor flaps.Step 2Adjust tractors for paper width. Green lever unlocks/locks (up i

Seite 2 - Quick Reference Guide

Quick Reference GuideAdvance PaperStep 1Press Online Key (places printer offline).Step 2Press FF Key.Step 3Paper advances.Step 4Tear off paper.Step 5P